F
IV
E
>
S
E
R
V
IC
E
46
bead and the wheel rim. If you have trouble getting the last few
centimeters of bead over the edge of the rim with thumb pressure,
use a plastic tire lever to push and slide the tire bead into its proper
seated position in the rim. Be careful again not to pinch the tube.
CAUTION:
If you use a screwdriver or any tool other than a
plastic tire lever, you are likely to puncture the tube.
Check to ensure the tire is evenly seated throughout both sides of
the rim and the tube is stuffed inside the tire cavity. Push the valve
stem into the tire to make sure that its base is seated within the
tire’s beads. Inflate the tube slowly to the recommended pressure,
(see Section 4.7) while checking to make sure that the tire beads
stay seated in the rim. It is useful to grab the tire and gently push/
pull along the entire tire to double check that the tube is not being
pinched and the tire is seated properly while inflating. Screw down
the valve stem locknut finger-tight. Replace the valve cap. Replace
the wheel in the bike (see Section 4.1).
IF YOU BREAK A SPOKE
Although there are many spokes in a wheel, even just one spoke
that becomes loose or breaks will affect the performance and
structural integrity of your wheel. If you break a spoke on your ride,
we recommend you walk your bike home if it is close by or ride the
bicycle very slowly and carefully so as not to break additional spokes.
If you choose to ride the bicycle home, twist the broken spoke around
the spoke next to it to keep it from flopping around and getting caught
between the wheel and the frame. Next, because the spoke is broken
(or loose), your wheel will not likely be “true.” Spin the wheel to check
to see if the rim clears any components or the frame. If the rim does
make contact and will not spin, it is strongly recommended to call for
a pick-up or walk the bike home.
5.3
IF YOUR BICYCLE SUSTAINS AN IMPACT
First, check yourself, and any others involved, for possible injuries
and treat as best you can. Seek medical attention immediately if
necessary.
Next, assess your bicycle for damage and fix what you can so that
you can return home safely. Have your bicycle assessd by your local
dealer for a thorough check to identify and service any damage. If
the bicycle is damaged beyond a safe use, do not attempt to ride and
contact a friend or family member for a ride home.
5.4
BATTERY CARE
We strongly recommend to always charge your battery after a ride
(if level of charge is less than a half). When removing and installing
the battery container, always check to see connections are clean and
free of water, dust or corrosion. If you notice any signs of corrosion
simply clean with a smooth brush.
WARNING:
For long-term storage, please store the
battery fully charged and recharge at least every 2 months.
Summary of Contents for bicycle
Page 49: ...ohmcycles com...
