OGSI OG-15, Installation, Operation And Maintenance Manual, Page: 9 / 57

Effective 07/2014 5
Safety Guidelines
Unpacking
A
DDITIONAL PACKAGING MATERIAL INSIDE THE UNIT MUST BE REMOVED AND THE AIR INLET
FILTER MUST BE INSTALLED PRIOR TO OPERATING THE OXYGEN GENERATOR
.
Ensure that the unit is NOT connected to an electrical outlet.

Remove the six (6) screws with nylon washers located on the front and both sides of the unit.

Lift the front cover up and away from chassis.

Remove packaging material from top, behind, and under the air compressor (drawing below).

Install air inlet filter (on top of the air compressor as shown below).

Install the front cover and secure the six (6) screws with nylon washers.
Air Inlet Filter
REMOVE
PACKAGING
MATERIAL.
FAILURE TO DO SO
WILL VOID YOUR
WARRANTY.
UNIT SHOWN WITH COVER REMOVED