Ogden RCR812, Owner'S Manual

Page: 17 / 52

Hay Runner™ Hay Rake 15 Ogden Metalworks, Inc. — 217-582-2552
Note: The tongue extension is required to mount the Dual Center Wheel
kit if purchased, as shown.
To remove the tongue extension, follow these steps.
1. Unfold both wings (all the way down), so the rake
wheels rest on the ground.
2. Unhook the hydraulic hoses from the tractor.
3. Loosen the hose holder clamp on top of the
tongue and move the hoses to the rear main
frame.
4. Use the jack stand to raise the front of the wheel
rake. Move the tractor away from the work area.
5. Place large, sturdy blocks under the center of the
main frame. Make sure the blocks, and the main
frame are stable before lowering the jack stand.
6. Lower the jack stand and remove it. All the
weight of the main frame should be resting on the
blocking.
7. Securely attach a lifting strap to the tongue.
Position the strap to balance the weight of the
tongue as it is removed.
8. Remove the six 5/8” bolts, lock washers, and nuts
connecting the tongue to either the main frame
or the tongue extension. Place the tongue away
from the work area.
CAUTION
The tongue weighs
approximately
96 pounds and may cause crushing injuries if
not handled properly.
9. If removing the tongue extension, securely attach
a lifting strap to the tongue extension. Position
the strap to balance the weight of the tongue as
it is removed. Remove the six 5/8” bolts, lock
washers, and nuts connecting the tongue to the
main frame.
CAUTION
The tongue extension
weighs approximately
80 pounds and may cause crushing injuries if
not handled properly.
10. Attach the tongue or the tongue extension with
six 5/8” bolts, lock washers, and nuts each.
Tighten the nuts to the standard torque.
11. Reroute and attach the hoses to the frame.
4.4 Attach the Tongue Assembly
Support the frame assembly.
CAUTION
Stay clear of the wheel
rake while it is
temporarily supported. Do not work under any
part of the unit.
1. Remove the six 5/8” bolts, lock washers, and nuts
connecting the shipping support stand to the main
frame.
2. Attach the tongue assembly using the removed
hardware.
3. Tighten the nuts to the standard torque.