Motor Switch:
This switch controls power to the Laminating Rollers. If the switch is
pressed to the FWD (light will come on) position the rollers move forward, pulling the
plastic film and laminated material past the Heat Shoes.
Reverse Switch:
This toggle switch is found on the back of the machine. When this
switch is pressed to the reverse position and the motor switch is on, the rollers move
in the reverse direction. This is useful for clearing film from the rollers.
Fan Switch:
This switch turns the fans on and off. (Switch will be lighted when the
fans are on).
Heater Switch:
This switch turns power to the top and bottom Heat Shoes on and off.
(Switch will be lighted when the heaters are on).
Heat Indicator:
This light goes on when the Heat Switch is first turned on then
remains on until the Heat Shoe reaches the operating temperature. After that point,
the light will flash periodically as the thermostat controls the Heat Shoe temperature.
OPERATION
This section describes the operation of your ML27. This laminator is designed for all
widths of plastic up to 27”. However, if narrower widths are used the Heat Shoes must
be cleaned before using a wider roll. Refer to the MAINTENANCE section for cleaning
instructions.
Loading Laminating Film onto Mandrels...
Slide the film onto the mandrel as in figure 2 below. Note that one mandrel is labeled
TOP and the other BOTT (for bottom). They are not interchangeable.
Figure 2
5
1-800-543-5454
OfficeZone
Summary of Contents for MightyLam 2700
