PROBLEM:
Blistering of the film appears over the item or along the edge.
ACTION:
Reduce temperature on one or both heat shoes. If the indicator light
remains on after the adjustment is made, disconnect the power supply and
contact your dealer.
Clean laminating rollers. See MAINTENANCE section for cleaning
instructions
There may be moisture in the paper you are laminating. Store paper in a dry
place and be sure that any ink is thoroughly dry before laminating.
PROBLEM:
Laminated material curls after leaving pull rollers.
ACTION:
Adjust tension. If laminated item curls upwards, reduce top roller tension.
If item curls downward, reduce bottom roller tension.
Clean heat shoes of residual adhesives as it may be causing “drag” on one
side. Refer to MAINTENANCE section for cleaning instructions.
MAINTENANCE
This section contains instructions for cleaning and maintaining your laminator. These
procedures should be preformed at regular intervals to help ensure the trouble-free operation of
your laminator.
Cleaning the Heat Shoes and Laminating Rollers...
The Heat Shoes and Laminating Rollers should be cleaned of any residual adhesive whenever
the film does not pass smoothly over their surfaces.
NOTE:
The surface of the heat shoes is Teflon coated and must only be cleaned using a
soft cloth. The Heat Shoes can easily be damaged by sharp or abrasive objects.
1. Allow the Heat Shoes to cool.
2. Remove the Feed Table.
3. Cut the plastic film at the top and bottom mandrels.
4. Turn the Motor Switch on and pull the film out of the back of the machine.
5. Turn the Motor Switch off.
13
1-800-543-5454
OfficeZone
Summary of Contents for MightyLam 2700
