Officezone MightyLam 2700, Operating Instructions Manual

Page: 14 / 26

10
Note:
You may want to run a test lamination first as any item
that passes between the Heat Shoes will be laminated and
cannot be recovered until it exits the rear of the laminator
5. Additional items may be fed in sequence, keeping enough distance between sheets for trim
ming.
6. After the last item has exited the Pull Rollers, turn the Motor Switch off.
7. Use the Zippy Cutter to cut across the film to remove the laminated items from the unit.
Coating Mount Board
The ML27 is capable of applying an adhesive coating on up to 3/16” uncoated mount board.
1. Load a roll of adhesive, with the liner wound to the outside, onto the top mandrel in the
same manner as with laminating film. Thread the liner side of the adhesive
over the top idler
roller (so that the adhesive does not stick to the idler roller) and then through the laminator as
with laminating film.
2. If the mount board is the same width as the roll of adhesive it is not necessary to load
anything onto the bottom mandrel. If the mount board is narrower than the adhesive, load a
roll of paper or film onto the bottom mandrel to keep the adhesive from accumulating on the
rollers and heat shoes. Thread as for laminating film.
3. Using the supplied allen wrench back out the four pressure adjustment screws about 1/4”
each. (Be sure to return the screws to their original position when going back to regular
sheet laminating).
4. Turn heat switch to ON position if heat is needed for the application.
5. Set the temperature to the desired setting, depending upon the type of adhesive used.
6. Feed the uncoated mount board into the laminator behind a leader board of the same thick-
ness. The leader board will prevent the compression of the leading edge of your mount board.
7. You may coat subsequent boards now, one directly behind the other, so that the board in
front becomes the leader board. If at any time you have adhesive going through the machine
without mountboard, be sure to pull the adhesive on the exit side of the machine to prevent a
wrap-around.
1-800-543-5454 www.officezone.com
OfficeZone