Officezone MightyLam 2700, Operating Instructions Manual

Page: 13 / 26

Caution! If the blade release knobs are turned too far,
the slitter blade may fall out of its guide and come in
contact with the rubber rollers. If this happens, the rollers
could be damaged. Never turn the blade release knobs
more than one turn to position the blades.
To adjust the slitter blades:
1. Be sure the slitter blades are positioned above the laminating web. If they are low-
ered, loosen the release knobs and lift the blades away from the web. Tighten the knobs
to lock the blades in place.
2. Loosen the positioning knobs (counter clockwise) and slide the slitter blades left or
right to the desired width of the edge seal. Lock the blades left or right to desired posi-
tion by turning the positioning knobs (clockwise).
3. Carefully, loosen each release knob and lower the blade in contact with the web.
Tighten the release knob.
4. To prevent accidental damage to rollers, remove slitter blades when not in use.
Figure 8
Laminating
1. Be sure the heaters have been turned on and are at the proper temperature. The fans should
be turned on for laminating 3mil and heavier.
Caution! Do not allow the temperature to exceed 350°F as this
could cause the laminating film to melt on the Heat Shoes.
2. Adjust the Paper Guide on the Feed Table so that the right edge of the item will enter the
laminator at the desired position.
3. Press the Motor Switch to the on position. The film will begin moving through the lamina-
tor.
4. After clear laminating film exits the Pull Rollers at the rear of the machine you may slide
the first item to be laminated into the laminator with the right edge along the Paper Guide.
9
1-800-543-5454 www.officezone.com
OfficeZone