Flashing Blue
Charging required, battery at 5~20%
7
Operating Instructions and Parts Manual
24493/24494/24499
11/18
2018 OEMTOOLS
™
R2 RECHARGEABLE
SPEED RATCHET
0.74 Ft/Lb. (1 Nm); at that time the user can change
over to manual driving mode.
5. When tightening fasteners, the final torque must be
applied manually to tighten the nut. DO NOT use
powered mode for final tightening.
6. R2 Rechargeable Speed Ratchet can operate in a
temperature of -4°F to 140°F (-20°C to 60°C) in power
mode.
Tool Indicator Light
CHARGING THE BATTERY PACK WITH
BATTERY CHARGER
•
Remove the battery pack from the tool for charging at a
convenient time. The R2 Rechargeable Speed Ratchet
batteries do not develop a “memory” when charged
after only a partial discharge. It is not necessary to run
down the battery pack before placing it on the charger.
•
You can “Top-Off” your battery pack’s charge before
starting a big job or an expected long period of use.
•
The only time it is necessary to charge the R2
Rechargeable Speed Ratchet lithium-ion battery pack
is when the battery pack has reached the end of its
charge. To signal the end of charge (indicator light is
continuous red), power to the tool will drop quickly. The
battery pack will need to be charged.
•
When using the R2 Rechargeable Speed Ratchet with
lithium-ion batteries, usage must halt and the batteries
charged immediately when LED indicator light shows
continuous red (low voltage protection). This is in order
to prevent damage and ensure product lifespan.
•
When lithium-ion batteries are left unused for over 3
months, they must be charged before use in order to
maintain their lifespan.
•
Lithium-ion batteries must be charged periodically in
order to maintain their lifespan.
HOW TO CHARGE THE BATTERY PACK
•
Align the battery pack with the bay and slide/insert
the battery pack into the battery charger as far as
possible. The LED light will come on, either flashing or
continuous.
•
A fully discharged battery pack with an internal
temperature in the normal range will charge in
approximately 45 minutes.
•
After charging is complete, the green indicator light will
stay lit.
•
The battery charger will keep the battery pack fully
charged as long as it is left on the charger.
•
If the indicator light does not come on, check that the
battery pack is fully seated into the bay. Remove the
battery pack and reinsert. If the indicator light still does
not come on, contact a service agent.
•
If the light continues to flash red and green at the
same time on the charger, the battery pack may be
excessively hot (104°F/40°C or more) or cold (32°F/0°C
or less). Allow the battery pack to cool down, warm up,
and then reinsert.
*
If the problem persists, contact a service agent. Once
the battery pack is within the acceptable range, normal
charging will take place.
Indicator Light
Status
Continuous Green
Power status normal, battery at
50~100%
Continuous Blue
Power status normal, battery at
20~50%
Flashing Red
Over current protection activated;
Automatic shut off.
Flashing Green
Over temperature protection
activated; Automatic shut off.
Battery pack temperature has
exceeded discharge range.
Continuous Red
Charging required, battery at
< 5%
Battery Charger Indicator Light
Indicator Light
Status
Continuous Red
Stand by
Continuous Green
Battery pack fully charged
Flashing
Red & Green
Not charging.
Battery pack temperature has
exceeded discharge range.
Charging will begin when battery
reaches the correct charging
temperature (0°~40°C (32°~104°F))
Flashing Red
Charging
Green Light
Red Light
Battery Holder
Power tool Holder
