SOME DO'S AND DONT’S FOR SAFETY AND LONG LIFE
1. Use the Proper hydraulic Fluid. KEEP IT CLEAN. Remember to change it regularly.
2. Lubricate all grease fittings at regular intervals.
3. ALWAYS BLOCK UP THE HOIST BEFORE WORKING UNDER IT.
4. Do not race the engine when unloading.
5. Do not overload the hoist beyond its capacity.
6. DO NOT TAMPER WITH THE HYDRAULIC RELIEF VALVE. This will void the
warranty. It can cause severe damage to the hoist and cylinder.
7. NEVER LEAVE THE PTO IN GEAR WHILE TRANSPORTING, IT WILL RUIN
THE HYDRAULIC PUMP.
8. Check all bolts and setscrews regularly.
HYDRAULIC FLUID
The capacity of the pump reservoir is 27 U.S. quarts. Five gallons of hydraulic fluid are required
for operation. KEEP IT CLEAN!! USE CLEAN CONTAINERS, FUNNELS AND
OTHER EQUIPMENT. Use a high quality hydraulic fluid of 150 SSU @ 100 degrees F. which
contains corrosion and oxidation inhibitors and foam depressant. For general use, a high quality
SAE 10W non-detergent motor oil with the proper additives, or type A automatic transmission
fluid can be used.
CRYSTEEL TRUCK BODY PROP
Crysteel's Body Prop is designed and intended for use to support an EMPTY truck body in the
raised position to permit service work to be performed safely beneath a raised body. DO NOT
GO BENEATH THE CONTAINER BODY UNLESS THE BODY IS EMPTY AND THE
BODY PROP IS IN THE PROPER POSITION!
CAUTION
UNLOAD BODY BEFORE USING BODY PROP!
OPERATION OF BODY PROP
1. Raise body to full height and shut off all power.
2. Raise prop to upright position.
3. Lower body SLOWLY until body bracket contacts prop.
4. DO NOT POWER HOIST DOWN.
SCL800 HOIST
CAUTION
PAGE 2
Summary of Contents for SCL800SM-3X
Page 113: ......
