10
9. install mast boot
a. Place the rubber mast boot (I) around the mast (B), covering
the open ends of the stationary handlebars.
b. Tuck the ends of the mast boot (I) into the channels in the
access panel (D) just below the stationary handlebars.
10. (Optional) csAFe connection
a
.
If your facility is using CSAFE, connect the CSAFE
RJ-45 cable to the CSAFE port at the base of the machine.
Tug the cable gently to ensure the connector is
completely seated.
11. Adjust levelers
a. Adjust all four levelers to make sure the product sits flat on
the floor. For a lower step up height, screw the rear levelers
into the rear stabilizer bracket. Then level the machine
using the front levelers.
b.
Tighten the leveler nut against the frame for each
leveler.
Note:
If you move your PRO370, you may need to
adjust the levelers to make sure your product
is level with the floor.
CAUTION
:
If the unit is not level, it may not function
properly.
