7
4. install console mast
a. Attach the console mast (B) by placing the keyhole slots in
the mast plate over the bolts on the cross trainer base (A)
and sliding the console mast toward the pedals.
b. Tighten the four 6mm hex key bolts attaching console mast
to frame.
c. Connect the black cable connector coming from the mast
to the black cable connector on the base frame.
Tug
the cables gently to ensure the connectors are
completely seated.
d. Use the cable tie (N) to secure any loose cable to the bottom
of the mast; cut off any excess cable tie.
5. mount the keypad to the console mast
a. Remove the two screws securing the console back piece
to the mast plate.
b. Connect the green grounding wire from the heart rate
board to the tab mounted on the frame (next to the green
console grounding wire).
c. Connect the contact heart rate cables from the top of the
console mast tube (two gray cables joined at one white
connector) to the open connector on the heart rate board.
d. Route the cable from the other end of the heart rate board
down through the top of the mast tube and out of the hole
beneath the console plate.
e. Connect the ribbon cable from the top of the keypad (2) to
the black cable connector from the top of the mast tube.
f
. Refer to the diagram at right to see all the connections
and the action required. Tug each cable gently to
ensure each connector is completely seated.
g. Position the keypad (2) on the mast (B) and insert each
of the four 12mm screws with washers (6) through the
mast holes and into the keypad back. Tighten screws to
secure.
Console/Keypad
(connect)
Heart Rate
(route)
Contact Heart Rate
(connect)
Keypad Ground
(no action
required)
Heart Rate
Ground
(connect)
CSAFE
(no action
required)
Note: If you are using the optional LCD Mounting Arm, skip step 6 of these instructions and
instead follow the instructions included with the LCD Mounting Arm. Once you have
completed those instructions, resume assembly of your PRO370 with step 7 of these
instructions.
