Connecting a monitor
To use a monitor or a flat panel, the Video jumper (W12[5–6]) must be
installed. This is the default configuration. The 16–pin connector at J18
supports an analog VGA/SVGA/XVGA CRT color or monochrome monitor.
Refer to figure 11–1 for a diagram of connecting a CRT, and table 11–1 for
the pin-out for J18.
The PC–600 supports both an analog monitor and/or a flat panel display.
The CT.COM and FP.COM programs allow you to toggle between the
monitor and the flat panel. If the flat panel supports simultaneous mode,
the SM.COM program will allow you to display images from both the
monitor and the flat panel at the same time. These programs are in the
Utilities zip file along with other diagnostic and configuration utilities
(see page 145). Refer to the README file.
To connect a monitor to the PC–600 you will need the following
equipment (or equivalent):
PC–600 CPU card
VGA-12 video cable, p/n 4865
VGA/SVGA monitor
To connect a monitor:
1.
Plug the VGA–12 adapter cable into J18 on the PC–600.
2.
Plug the DB–15 end of the VGA–12 cable into the VGA cable of the
monitor.
Refer to Figure 11-1.
87
