Octagon PC-510, User Manual

Page: 34 / 239

2-1
PC-510 user’s manual Quick start
Chapter 2:
Quick start
This chapter covers the basics of setting up a PC-510 system and tells you:
n
How to install and power on the PC-510 and run a demo program
n How to use a serial console instead of the on-board SVGA video.
Follow the mounting procedures for the PC-510. To establish a serial
console link, go to the Serial console section in the Console devices chapter.
≡
Installing the PC-510
To install the PC-510 you will need the following equipment
(or equivalent):
n PC-510 Mobile Industrial Computer
n +5V power module
n AT compatible keyboard with PS/2 connector
n VGA monitor
n VGA-12 cable
1. Refer to the PC-510 component diagram (Figure 2-1) for the location of
various connectors, before installing your PC-510 system.
WARNING!
The PC-510 Mobile Industrial Computer contains static sensi-
tive CMOS components. Do the following to avoid damaging
your card and its components:
n
Ground yourself before handling the PC-510 card
n
Disconnect power before removing or inserting a PC/104
expansion card
n
When programming a memory device, place the device in
the socket before applying power.
Hardware components required to mount the PC-510:
n 8 threaded hex stainless steel standoffs (4-40 x 3/8")
n
8 screws (4-40 x 1/4")
n 8 internal star lock washers (4-40)
2. Use the #4 standoffs, washers, and screws and place them in the eight
holes on the PC-510 board. Refer to Figure 2-2 for the center-to-center
mounting hole dimensions and for the location of the designated holes used
for mounting the hardware.