Ochsner AIR FALCON 212 C11A T200, Design And Installation Manual

Page: 19 / 68

00_400_200_202_02_split_Planung_Errichtung-EN | www.ochsner.com 19
Indoor unit
Material damage
PU foam is not suitable as a sealant for the pipe
liner.
7. Indoor unit
7.1 Installation location
Material damage
The indoor unit is intended to be installed inside the
building only. It must not be installed in rooms with
high levels of humidity (permanently above 70%).
The installation room for the indoor unit must meet the
following requirements:
► A dry and frost-free room
► Sound optimised environment
► A horizontal floor with adequate load bearing capacity
for the weight of the indoor unit
► Not directly below or next to rooms that are sensitive
to sound (e.g. bedrooms)
► Max. room temperature 30°C
► Installation room must not be subject to a risk of ex-
plosion arising from dust, gas or vapour
7.2 Keep minimum clearances
Observing the specified minimum clearances for the indoor
unit ensures:
► Correct installation of the appliance
► That it operates fault-free
► Ability to carry out maintenance on the appliance
»
Observe the machine-specific minimum clearances.
Note
The machine-specific information on engineering
and preparation can be found in this document‘s
machine-specific engineering and preparation sec -
tion.