13
English
H. Warning Label
a
b
c
d
e
f
g
(a) Sound Level (Reference value)
(b) WARNING
(c) Read the instruction manual carefully.
(d)
Thrown or flying object.
(e) Wear head, eye and ear protectors.
(f) Do not work removing cutting attachment guard.
(g) Arrow to represent idea of keeping safe distance away from
hazard. Keep bystanders at least 15m away.
Frame Serial Number
The frame serial number (J) is the only means of identifying your
particular products from others of the same model type.
The frame serial number is needed by your dealer when
ordering parts.
Installation of the Cutting Head
G
F
E
B
C
A
D
●
In case of affixing the nylon cutter, put parts in place in the
following order: holder upper (A), glass cover (B), holder
lower (C) and nylon cutter.
●
Fix the holder in place using as Allen wrench (E).
●
Rotate nylon line feeder (D) in counterclockwise direction unit
securely tightened.
●
Attach the nylon cord guard (G) to the safety guard (F).
●
Insert the Allen wrench (E) into the hole at the gear case
cover.
●
Rotate the output shaft until the Allen wrench slips into
position and blocks the output shaft.
OPERATING INSTRUCTION
Preliminary Checks
●
Adjust the handle to a comfortable position and maintain good
balance as recommended in this manual.
●
Make sure the unit is assembled properly.
WARNING
Hold the unit down firmly so you do not lose control
while cranking. If not held down properly engine could
not pull you off balance or swing the cutting line into an
obstruction or your body.
●
Keep the unit and attachments
in good working condition.
Tighten fasteners at regular
intervals. Check the cutting
head assembly before each
use.
WARNING
Thoroughly inspect the area where the unit is to be used
and remove all stones, sticks, wire and other objects
that could cause injury if thrown at high speeds.
●
Never operate the unit without proper guards, shields or other
safety protective devices in place and properly connected.
Inspect to determine that these safety devices are installed
properly, are in good condition and operate properly. If the
condition or operation of these devices is abnormal, they must
be repaired or replaced before using the unit.
WARNING
Removing the cutter guard can cause damage to the
drive shaft/cable (not covered by warranty) and cause
serious injury to operator and others.
●
Make sure the cutting head stops turning when the throttle
trigger is released and the engine runs at idle speed.
●
DO NOT use any accessory or attachment other than those
supplied by the manufacturer for use with this particular unit.
●
Use only for jobs explained in this manual.
●
Inspect the entire units before each use for work, Loose
or damaged parts. DO NOT use until the unit is in proper
working order.
●
DO NOT attach any blade to a unit without proper installation
of all required parts.
Summary of Contents for DP-10
Page 2: ......
