Oceanic VEO 1.0, Operating Manual

Page: 58 / 68

58
Battery Installation
• Slide a new 3 volt type CR2450 Lithium Battery, ( - )
negative side down into the Battery Compartment. Slide
it in from the right side and ensure that it slides under the
contact clip on the left rim (Fig. 65).
• Orient the Retaining Bar across the lower portion of the
Battery and carefully push it down into position (Fig. 66).
Battery Hatch and Hatch Retaining Ring Installation
• Lightly lubricate a new Cover O-ring* with silicone grease
and place it on the inner rim of the Battery Cover (Fig. 67).
Ensure that it is evenly seated.
*The O-ring must be a genuine Oceanic part that can be purchased from an
Authorized Oceanic Dealer. Use of any other O-ring will void the warranty.
• Slide the Cover Ring, top portion first (small opening), onto
your thumb.
• Carefully place the Battery Cover (with O-ring) into position
on the rim of the Battery Compartment, then press it evenly
and completely down into place with your same thumb.
• Maintain the Battery Cover securely in place and, using
your other hand, slide the Cover Ring down off your thumb
and into position around the Battery Compartment.
• The tabs on the Cover Ring fit down into the two slots
located at the 2 and 8 o'clock positions.
Fig. 65 - BATTERY
Fig. 66 - RETAINING BAR
Fig. 67 - COVER O-RING