![background image](http://html1.mh-extra.com/html/ocean-guardian/boat01/boat01_user-manual_3217643031.webp)
DRAFT
© Ocean Guardian 2019
31
BOAT01 / FISH01 Manual v1.3
Care and Maintenance of Ocean Guardian Cable
and Antenna Connectors
The sub-sea connectors require very little maintenance. They are
designed to be used in harsh environments and limited amounts of
dirt and grit do not affect their performance. It is recommended
that, upon disconnecting or retrieving the system, the connectors
are cleaned, to storage (if possible, remate with dummy plugs).
Prior to deployment the following maintenance procedure is
recommended:
1. Demate the connector set.
2. Flush connector interface with fresh water (deionized water if
available), remove all dirt, grit and grease.
3. Inspect for damage in sealing areas, excessive corrosion,
debonding of the cable and connector interface and cuts in
the cable jacket.
4. Apply a thin film of dielectric compound (DC) grease, silicon
based, to sealing areas of male connector and across the
face of the female connector*. If the BC is removed from it’s
housing then replace facial o-ring and make sure that o-
rings are lubricated and in good condition.
5. Mate the connector halves, wipe away any excess grease
off the interface line of the mated set.
CAUTION:
·
*The use of some oil-based propellants in spray cans can
cause conductivity problems in neoprene.
·
Only qualified technicians should perform the installation
and maintenance of connectors on charging cables and
antennas
Cable and Antenna Connector Continuity
Preservation
Avoid sharp bends in cables. Cables subjected to vibration or
exposed to seawater drag should be adequately clamped to
prevent conductor fatigue and ultimate failure.
Summary of Contents for BOAT01
Page 1: ......