Oce TDS300, User Manual

Page: 26 / 132

26 Océ TDS300 User Manual
▼
Cut the material from roll 1 or roll 2
1
Open the drawer.
2
Feed the paper manually until it is 5 cm above the top drawer.
3
Press the On-line key to put the printer off-line.
4
Close the paper drawer.
5
Select the ‘Media settings’ item with the or key.
6
Press Next/select to enter the ‘Media settings’ menu.
7
Select ‘Cut media’ with the or key.
8
Press Next/select to cut the paper.
9
Open the paper drawer.
10
Remove the scrap of material.
11
Feed the material until you can see the material and put the material into
position (see figure 25 on page 91) and (see figure 29 on page 93).
12
Close the drawer.
13
Press the On-line key to put the printer on-line again.