Oce im2330, Network Administration Manual

Page: 50 / 76

2 Troubleshooting
48 Troubleshooting Overview
Unix Environment:
Cannot Discover Device
Problem Description
This equipment is discovered automatically using SNMP.
When Document Monitor, TWAIN driver, File Downloader, and Address Book Viewer cannot
automatically discover this equipment over the network, the most likely cause is limitations of the
protocols on the supporting computers. In some cases, you need to add or update network com-
ponents.
The following checklist helps you identify the source of the error and directs you where you can
find more information about resolving it. If the problem persists after you have followed all of the
steps, contact a authorized dealer for further assistance.
No Check... Yes No For Instruction, Go To...
1 Are the IP Address proper-
ties correctly set?
Next Step
Ø
Ö
Setup the IP address correctly.
2 Is the LPR/LPD Printing cor-
rectly set?
Next Step
Ø
Ö
Setup the LPD print service cor-
rectly.
3 Did you successfully install
the Unix filters?
Next Step
Ø
Ö
See the Printing Guide to install
Unix filters.
4 Did you successfully create
and set up the print queue?
Next Step
Ø
Ö
See the Printing Guide to config-
ure the print queue.
5 Can you print to this equip-
ment using LPD as root?
Next Step
Ø
Ö
Setup Unix access for this equip-
ment to enable other users to
print from the Bourne shell. Refer
to your Unix documentation for
more information.
6 Can you ping this equip-
ment from your computer?
Next Step
Ø
Ö
Try remote ping from another
server. If you can reach this
equipment from that server, check
for conflicts between this equip-
ment and your current network
segment.
7 Is the LP Daemon function-
ing?
Next Step
Ø
Ö
Reload Daemon or restart the
system.
8 Can you print to this equip-
ment?
End Ö
Contact your service representa-
tive.
No Check... Yes No For Instruction, Go To...
1 Is the SNMP enabled on
this equipment?
Is “public” is specify for the
Read Community?
Is “private” is specify for the
Read Write Community?
Next Step
Ø
Ö
Enable the SNMP (MIB) and con-
firm the Read Community and
Read Write Community setting.