Oce Arizona T220, User Manual

Page: 56 / 79

Océ | Operating the Arizona T220
5-46 3010100686-A
Place Media Menu
The menu now displays the following pre-print message:
Media Height Check
The desired media height is first selected on the computer and then verified at the control
panel prior to printing. The print heads will adjust to the desired height and the gantry
will move into the printing position over the media. As a precaution against damaging
the printheads, there is a flipper arm in front of the printheads used to detect the media
height. If a wrong media height is detected, the flipper arm will cause the gantry to stop
and the control panel will alert the operator of the problem.
Printing Direction
When printing begins, the image start point is the lower right corner of the image and
the media is right justified toward the capping station.
Figure 22 T220 Printing Direction
Print Mode
speed 1x
Place media on table. Turn vacuum ON.
Press ACCEPT to start printing