Oce Arizona T220, User Manual

Page: 22 / 79

Océ | Ink System Management
2-12 3010100686-A
2.3.1
Refilling the Solvent Bottle
Solvent is used to maintain the capping station. The solvent supply bottle is located on
the end of the ink station tray, to the right of the ink bottles. A sensor monitors the
solvent level in the bottle. A low solvent level causes a message to display on the control
panel.
Figure 3 Ink Station tray showing Solvent Bottle
Refill the solvent bottle when the control panel indicates the solvent is low. Top up the
solvent bottle if the printer is to be left unattended longer than overnight. To refill the
solvent bottle:
1. Unscrew the lid and remove the coupler. Remove the solvent bottle from the Ink
Station Tray before filling. This prevents spilling of solvent on the painted metal
surfaces or the solvent level sensor;
2. Place the funnel (Part #3010100404) into the off-center hole in the ink pick-up
insert inside the solvent bottle and fill the solvent to the level of the shoulder on the
bottle.
3. Set the bottle on the tray and replace the coupler by inserting it fully into the hole in
the lid. Screw the lid back on securely.
Note: Tapping the sides of the lid on a new 1 gallon solvent container will ease the
removal of the lid.