12
SECTION 2: INSTALLATION
Drop cable
Pendant
adapter
Align
marks
Safety rope
Coupling
Pendant adapter
Back box
8.
Fit the camera coupling into the pendant adapter, then twist the camera to align the marks on the pendant adapter and the
camera back box. See the figure above.
9.
Tighten the two lock screws on the pendant adapter to secure the camera to the mounting bracket.
10. Feed the camera drop cable through hole drilled at the mounting location, then anchor the mounting bracket to the wall.
11. Continue installation with “2.4 Connecting the cables” on page 13.
2.3 Ceiling mounting
Following the instructions below to install the camera using the
BLK-PTCL Ceiling Mount Bracket
.
1.
If you did not setup the camera DIP switches using “2.1 Setup the camera address and baud rate DIP switches” on page 8,
remove the camera dome cover, remove the protective foam, then reinstall the cover. See Section 2.1 steps 1, 2 and 7 above.
2.
Determine the best mounting screws and hardware to anchor the mounting bracket with the camera to the mounting
surface. Use the following guidelines:
—
For cement ceiling mounting, use the expansion screw to anchor the bracket.
—
For wooden ceiling mounting, use self-tapping screw to anchor the bracket.
—
Make sure that the ceiling is strong enough to withstand more than
8 times
the weight of the camera and the bracket.
3.
Using the mounting bracket as a template, mark the location of the mounting screw holes on the ceiling.
Summary of Contents for The BLACK Line BLK-PTZ36X
Page 8: ...viii TABLE OF CONTENTS...
