TD851W
150Mbps Wireless N ADSL2+ Modem Router User Guide
¾
MAC Address Control:
The router supports the MAC address control on Ethernet port.
Select the LAN interface on which you want to run MAC Address Control. Click the
Apply
Changes
button to make the configuration take effect. For example, if you enable the MAC
address control on “LAN1”, then the traffic from interface “LAN1” will be flowed only when its
MAC address matches the
Current Allowed MAC Address Table
, otherwise the traffic will
be dropped by the router.
¾
New MAC Address:
This field allows you to add a new MAC address to the
Current Allowed
MAC Address Table
. To add a new MAC address, enter the MAC address and then click
Add
button.
¾
Current Allowed MAC Address Table:
Displays the current allowed MAC address. Click the
Delete
button and then the corresponding MAC address will be deleted.
After configuration, click
Apply Changes
button to save your changes.
)
Note:
After configuration, you need to click the
Save
button appeared on the left panel so that your
configuration can still take effect after the Router reboots.
4.2.2.2 DHCP
Choose “
Setup
→
LAN
→
DHCP
” menu, and then you will see the DHCP Mode screen (shown in
Figure 4-7). Here you can configure the DHCP mode of your ADSL Router as None, DHCP Relay
or DHCP Server. DHCP stands for Dynamic Host Control Protocol. The DHCP Server gives out IP
addresses when a device is booting up and request an IP address to be logged on to the network.
24
