4. Press the SEAL button to begin sealing; the signal lamp turns on. When
the SEAL lamp turns off, the sealing is complete.
5. Lift the handle to open up the cover of the device. Remove the finished
vacuum bag. The vacuum bag is now ready to use for vacuum packing.
Important tips when vacuum packing
•
Do not put in too much ingredients in the vacuum bag. Leave at least 7 cm
between the contents of the vacuum bag and the bag opening.
•
Make sure that the vacuum bag is dry in the opening, as the bag will not
be properly sealed otherwise. One tip is to fold down the edge around the
bag before putting the produce in the bag so that the top of the bag stays
dry/clean. Then fold the edge again before closing.
•
Extend the bag opening before it is placed against the sealing unit to
remove any folds and unevenness.
•
Do not place sharp objects such as fish bones and hard shells in the
vacuum bag as they may penetrate the bag.
•
During the vacuum packing process, liquid and other particles can
unintentionally end up in the vacuum pump, which can clog the pump and
damage the device. To prevent this, we recommend that liquid contents
be frozen in freezer-resistant containers before it is vacuum packed in a
vacuum bag. Also refer to the section “Preparation guide for various kinds
of produce”.
•
If you are going to vacuum pack meat or other moist contents, some paper
towels can be placed between the contents and the bag opening. When
vacuum packing flour, grain and other powder contents, a coffee filter
can be placed between the contents and the bag opening. Make sure the
paper/filter is not placed in the seal.
•
Note that vacuum packed perishables must be stored in the refrigerator
or freezer. Remember that vacuum packing is not the same thing as
preserving, but rather only extends the shelf life.
•
Keep in mind that food that has a high fat content can spoil if it is stored
too warm.
•
Vacuum packing of fruit and vegetables, such as apples, bananas,
potatoes and root vegetables does not extend their shelf life if they are not
peeled first.
Vacuum packing
Vacuum packing with a vacuum bag
Place the device on a flat surface and plug it into a wall socket. All signal lamps
light up shortly and then switch off, except for the Dry lamp that continues to
light.
1. Place the contents to be vacuum packed in a vacuum bag, leaving at least
7 cm between the contents and the opening of the vacuum bag. Only use
vacuum bags/plastic rolls from OBH Nordica.
55
Summary of Contents for PRIME 7953
