OBH Nordica 1387, Instructions Manual

Page: 28 / 36

28.
Assembly
1. Put the base stand on the base plate in glass.
Tighten the base screws from below in the glass
base, with the small washer closest to the screw-head
and the paper washer at the end.
2. Unscrew (anticlockwise) and remove the clamping nut that’s
positioned on the motor shaft. Mount the rear guard by fitting
the holes onto the 3 pillars. The guard is marked ”UP” to
show which direction to mount on the motor shaft. Fix the
clamping nut on the motor shaft and make sure it’s tightened
properly.
3. Position the fan blade on the motor shaft. Fix the blade cap on the mo-
tor shaft by screwing it anticlockwise.
4. Check the operation of the blade by turning it by hand, the blade
should not touch any part of the assembly. If the blade doesn’t turn
freely, disassemble it and repeat the process.
5. Attach the front guard’s centre hook to the rear guard and push them
together until you hear a click sound.
6. Close the guard clip to lock the front and rear guards together. Tighten
the screw positioned underneath.
7. Adjust the height by loosen the height fixing screw and the pull up or
push down the tube to desired height. Tighten the scew properly.