Use
Place the fan on the floor. Remove the cable tie and unravel the cord set
completely. Connect the plug to mains supply.
Remote control
Open the battery lid by sliding it down. Insert 2 batteries type AAA 1,5 volt
and be careful to place in correct direction, noting the polarity marked on
the casing. Replace the lid. The range of the remote control is 3,5 metres.
If the remote control is out of transmission range from the fan, the settings
you make via the remote control will not be activated, even if these are
shown in the remote control display. Then push the
OK-button
to
synchronize the remote control and the fan – the settings will be activated
and also shown in the fan LCD-display.
The display on the fan base stand as well as the display of the remote
control will show current settings.
Functions
Start the fan and set the speed by pressing the switch
”ON 1-2-3”. Press ”OFF” to turn off the fan.
Speeds
= low speed
= medium speed
= high speed
Fan modes
There are 3 different fan modes. Push the Mode-button
to choose:
Breeze = Imitates a natural outdoor breeze. The speed is adjusted up and
down in different cycles.
Sleep = The speed goes up and down during the first 30 minutes, there-
after the fan is operated on a lower speed.
Temp = The airflow is automatically adjusted depending on the room
temperature.
29.
Summary of Contents for 1387
