G. THERMOSTAT REPLACEMENT (CONTINUED)
Limiter Control
(see figure 11)
1. Follow steps 1 and 2 from Primary Thermostat.
2. Remove tank feed and vent silicone tubing from
reservoir bottom.
3. Remove upper reservoir by releasing the (3) clips.
4. Remove both wires from limiter thermostat.
5. Using a ¼ inch nut driver remove both screws from
bracket.
6. Replace limiter control using the reverse order.
H. INSPECT AND REPLACE HOT FAUCET
J. HOT TANK MAINTENANCE
NOTE:
Over time the hot tank and hot water ways may develop mineral build up which can narrow waterways
affecting pot volumes and hot faucet draws. Mineral build up may occur sooner or later depending on
the TDS level of the supply water to the brewer.
Mineral build up may occur over time causing a
slower than normal flow rate from hot faucet.
Periodically inspect the faucet outlet (see figure
6) for mineral build up. Also check for mineral
build up, obstruction or kinking of the silicone
tube from the hot tank to the hot faucet. If build
up is abundant, the hot faucet may need to be
replaced. For replacement see instructions
below.
1. Drain hot tank (see Section C steps 1-8)
2. Remove silicone tube from hot faucet.
3. Remove (4) front panel assembly screws
from inside cabinet.
4. Remove (2) faucet bracket screws from
front panel assembly.
5. Loosen hot faucet nut and remove faucet
from bracket.
6. Replace hot faucet using the reverse
order.
NOTE: If dripping from hot faucet occurs, the
bonnet (see Figure13) may be too
loose. To tighten, turn bonnet one
quarter turn clockwise.
Figure12
Hot Faucet Assembly
Remove (4)
Screws
Remove (2)
Screws
I.
FLOAT CAP AIR FILTER (see figure 8)
NOTE:
If brewer is moved while filled with water, splashing from the upper reservoir may cause the air filter on
the float cap to get wet. When moving or transporting brewers, make sure the tank is drained enough
that the upper feed reservoir is not holding any water.
NOTE:
Make sure the air filter is completely dry of before setting the pot volume.
If the filter media inside the air filter is wet during the programming of a pot volume, it may cause variances in pot
volumes for subsequent brew cycles. Make sure the air filter is completely dry of before setting the pot volume.
If the filter media inside the air filter gets wet anytime after the programming of pot volume, it may cause erratic
pot volumes.
Hot Faucet
Bonnet
Figure 13
Hot Faucet