Oase ProfiClear Premium TF-XL, Operating Instructions Manual

Page: 69 / 444

- EN -
69
How to proceed:

S
1. Remove the container cover.
– The filter drum is stopped for safety reasons if the filter cover is lifted and
Er11
is indicated
in the display of the control system.
2. Switch off the filter pump.
3. Switch off the mains voltage (ensure that the control system is isolated).
4. Measure the distance between the top edge of the container and the level of the water and
determine the necessary position of the holder according to the table.
5. If the determined position differs from the current position, correct it as required.
– Undo and remove both screws of the holder. Push the holder into the correct position and
fasten with both screws.
6. Fit the container cover.
7. Switch on the control system and filter pumps and check the function of the status detection.
The status detection is correctly set if the float sinks with the filter pump switched on and the
system message
Er88
is only triggered 10 minutes after the filter pump is switched off.

S Water level in the filter container/pond
(measured from the top edge of the container with the filter pump
switched off)
max. min.
169 mm 189 mm 9
162 mm 182 mm 8
155 mm 175 mm 7
148 mm 168 mm 6
141 mm 161 mm 5
134 mm 154 mm 4
127 mm 147 mm 3
120 mm 140 mm 2 1)
113 mm 133 mm 1
1) Factory setting