Oase Lunaqua 2, Operating Instructions Manual

Page: 10 / 94

- EN -
10
Maintenance and cleaning
W A R N I N G
Possible death or severe injury from hazardous electrical voltage!
• Prior to reaching into the water, isolate (switch off and disconnect) all units/devices used in the water.
• Isolate the device (disconnect from the power supply) before carrying out any work on it.
If necessary, clean the unit with clear water using a soft brush.
• Ensure that no moisture can enter the unit.
Remedy of faults
Issue Cause Remedy
Lamp does not light up − device does not receive power
− bulb defective
− bulb contacts have corroded
− check power connection
− change bulb
− clean contacts
Reduced performance/ Dimming − glass lens is dirty − clean lens
Water in the lamp body
− gasket is defective / not installed correctly − check gasket and replace, if necessary
Light is flickering
− bulb contacts corroded − clean contacts
Wear parts
• Bulb
Repair
Neither the transformer nor the spotlight can be repaired in the event of damage to the cables or the housing and must,
therefore, be replaced.
Spare parts
The use of original parts from OASE ensures continued
safe and reliable operation of the unit.
Please visit our website for spare parts drawings and spare
parts.
www.oase-livingwater.com/spareparts
Disposal
N O T E
Do not dispose of this unit with domestic waste.
• Render the unit unusable beforehand by cutting the cables and dispose of the unit via the return system
provided for this purpose.