Oase InScenio FM 1, Operating Instructions Manual

Page: 7 / 72

7
- GB -
Safe operation
−
Protect the unit from moisture and rain.
−
The unit is not suitable for completely isolating the units connected to it.
−
Never operate the unit if either the electrical cables or the housing are defective!
−
Do not carry or pull the unit by its electrical cable.
−
Route all cables such that damage is excluded and nobody can trip over them.
−
Never open the unit housing or its attendant components, unless this is explicitly required in the operating
instructions.
−
Only use original spare parts and accessories for the unit.
−
Never carry out technical modifications to the unit.
−
Only have repairs carried out by customer service points authorised by OASE.
Installation and connection
This is how to connect the power supply:
−
Insert the speed controller into the socket.
−
Observe the specified safety distance of the unit from the water (B).
−
Insert the plug of the pump connection cable into the speed controller.
Proceed as follows to fit the holder for the hand-held transmitter:
−
Take the hand-held transmitter (C, 2) out of the holder (3).
−
Screw the holder (3) e.g. to an indoor wall using the enclosed screw (4).
Operation
Teach-in hand-held transmitter again
Note!
−
The unit is operated using the hand-held transmitter.
−
Before using the hand-held transmitter for the first time (D, 2), remove the plastic strip (5) so that the battery
makes contact.
−
Press the respective key on the hand-held transmitter for approx. 1 s to ensure that it switches correctly.
When a key is pressed, the LED lights up.
How to operate the unit:
Switching the pump on and off
Press the I key once: The pump is switched on and controlled at the most recently saved
speed value.
Press the 0 key once: The pump is switched off. The current speed value is saved.
Controlling the pump (the pump is switched on)
Press the I key: The speed value changes continuously. The fountain height/flow
quantity changes accordingly.
Press the I key again: The current speed value is set.
Remedy of faults
Malfunction Cause Remedy
LED on the hand-held transmitter does not light
up when the transmitter is operated Battery in the hand-held transmitter is dead Change battery
Interference over radio distance Choose a different place, ensure unobstruc-
ted view
Hand-held transmitter defective Replace hand-held transmitter
Unit defective Replace unit
Mains voltage switched off Switch on mains voltage
Unit does not respond to commands from the
hand-held transmitter
Connected pump is not working Read the pump operating instructions.
Connect the pump directly and check its
function