NXP Semiconductors
JN5189
JN5189-DK006 Development Kit User Guide
UM11368
All information provided in this document is subject to legal disclaimers.
© NXP Semiconductors N.V. 2020. All rights reserved.
User Guide
Rev.1.1
— 28 April 2020
11 of 21
3. JN5189 Modules
JN5189 Module board is the JN5189 minimum system board. The module should be
mounted to carrier board as the target. There is a RF connector on this board, which can
be used to RF signal testing.
4. Generic expansion board
This expansion board is available in the development kit and is compatible with Arduino
shields. They are supplied pre-fitted with Arduino-compatible header of Carrier Boards in
the development kit.
The Generic Expansion Board has the following features:
•
Arduino-compatible expansion header (in four parts, CN1-CN4)
•
4 user-input buttons (SW1, SW2, SW3, SW4) connected to DIOs on
the JN5189 module on the Carrier Board:
o
SW1 is connected to IO19
o
SW2 is connected to IO15
o
SW3 is connected to IO7
o
SW4 is connected to IO4
•
4 LEDs (D1, D2, D3, D4) connected to DIOs on the JN5189 module on
the Carrier Board:
o
D1 is connected to IO16
o
D2 is connected to IO6 (same as for the PWM output used
on the Lighting/Sensor Expansion Board to drive the three
white LEDs)
o
D3 is connected to IO3
o
D4 is an optional LED which is not fitted on the supplied
board and shares IO4 with button SW1
•
Potentiometer connected to JN5189 ADC0, with a 0-1.8V DC voltage
swing
•
Infrared Emitting LED Vishay VSMB2948SL connected to JN5189
IO20_IR_Blaster
Figure 6 JN5189 module board
