JN517x-DK005
Development
Kit
User Guide
JN-UG-3121 v1.1
© NXP Semiconductors 2017
31
Step 8 Bind the Dimmer Switch to the Dimmable Light
It is now possible to bind the Dimmer Switch to the Dimmable Light (so that they will
operate together).
To bind the Dimmer Switch to the Dimmable Light:
a)
Press and release the Commissioning button (GPIO4) on the Carrier Board of the
Dimmable Light node. The three white LEDs on the Lighting/Sensor Expansion
Board will flash.
b)
Press and hold down the Commissioning button (GPIO4) on the Carrier Board of
the Dimmer Switch node.
c)
Press and hold down the SW2 button on the Generic Expansion Board of the
Dimmer Switch node for up to 10 seconds (or longer) until the three white LEDs
stop flashing on the Lighting/Sensor Expansion Board of the Dimmable Light
node. If these LEDs fail to stop flashing, press the RESET button on the Carrier
Board of the Dimmable Light node and restart the procedure from Step 8a
(above).
d)
Release the button GPIO4 on the Dimmer Switch node.
e)
Repeat sub-steps 8a to 8d above but pressing button SW3 instead of SW2 on the
Dimmer Switch node.
The Dimmer Switch is now in Control mode and can be used to control the Dimmable
Light, as described in
.
Note:
If you wish to unbind the two nodes, you can do
this from the Carrier Board of the Dimmer Switch node,
as follows: press and hold down the RESET button,
then press and hold down the GPIO4 button, then
release the RESET button and finally release the GPIO4
button.
