• 13
Delay Function:
The purpose of this function is to allow for set programs to start at a later time.
To delay a program, press “Prog,” then press the “Time” button. A “0” will flash in the lower
right corner of the display panel. Press the “+” button until the desired amount of time you
wish to delay the program start is reached (for more information, review SETTING TIME
on the top of this page). Then press “Prog” again to set cooking program. The amount
of time selected for delay is included in the programmed stages. To continue to the next
stage, enter the cooking temperature. Continue with step #2 from the “PROGRAMMING
FUNCTION” instructions. Once ready for the countdown to begin, press “Start.” When
delay countdown reaches “0,” the NuWave PIC Titanium will beep twice to signal the end.
At this point, the cooking time will start and the temperature will be displayed.
Programming Function (Stage Cooking):
• Press the “Prog” button.
• “Pro” will appear in the display panel.
1. Input the desired set temperature, ranging from “Low” to “Max/Sear.” If you
need to increase or decrease the temperature, press the “-” or “+” buttons.
2. Press the “Time” button. 00:00 will appear on the display, then press the “-” or
“+” buttons until you reach the desired time. See above section “SETTING
TIME” for detailed information on how to enter minutes and hours.
•To add additional stages, repeat steps 1 and 2 and then press “Start” to begin your
program. You may program up to 10 stages (delay is considered a stage).
•If you need to change any part of the program, press the “Pause/Clear” button twice to
start over.
Example:
In order to boil for 5 minutes before reducing to simmer for 20 minutes, press
“Prog,” then press the “Max/Sear” button. Press the “Time” button once, then press “+”
until you reach 5. Press “Med/Low” next, then press “Time” twice, then “+” until you reach
20. Finally, press “Start.”
NOTE: Maximum programmable cook time is 99 hours and 60 minutes.
Pause / Clear Function:
To interrupt cooking time, press the “Pause/Clear” button once. This will pause the
NuWave PIC Titanium at whatever might be the current stage. The temperature will
remain listed in the display panel, but the “F” will be blinking. To resume, press “Start.” To
CLEAR the cooking mode or display while the NuWave PIC Titanium is in operation, press
the “Pause/Clear” button twice. The screen will be fully cleared, a “0” will appear and the
unit will turn off.
Setting Cooking Time
:
Press the “Time” button. A “0” will flash in the far right corner of the display panel. Press
the “+” button until you reach the desired amount of time. Examples: To program 5
minutes press “Time” once, then press “+” until you see 00:05 on the display. Then press
“Start.” For 20 minutes, press “Time” twice, then press the “+” button until you see 00:20,
then press “Start.” For 2 hours and 30 minutes, press “Time” twice before pressing “+”
until you reach 3, then press “Time” again. Press “+” until you reach 2 (the display will
show 02:30), then press “Start.”
• The blinking “0” indicates the digit you can adjust. The maximum time is
99 hours and 60 minutes.
• The display shows hours and minutes, but not seconds.
Owner’s Manual
• 13