EN
EN
Replacing Shifter Cables
Remove cable hardware from both
cables and remove shift cables
from housing.
Adjusting Cable Slack
Cable slack can be adjusted
with the barrel adjusters
(1)
at the
shifter
.
Cable slack can be deter
mined
by pulling lightly on the cable
housing
(2)
at the shifter and
noticing any slack.
f
0.5mm of slack is ideal. Cable
slack of more than 2.0mm may
cause decreased shift per
for
-
mance and shift cable durability
.
f
For rear wheel removal, ad-
ditional cable slack may be
desired to ease shift cable
hardware removal, which can
be obtained with the barrel
adjusters.
4. BASIC MAINTENANCE AND CARE
Lubrication
f
The
NuVinci
N360 CVP is
provided with per
manent
lubrication and the CVP
inter
nals are maintenance-free
for the life of the product.
f
The
NuVinci
N360 inter
nal
freewheel mechanism is
ser
viceable.
f
Regular lubrication will extend
the chain’
s ser
vice life.
13
14
Cleaning
f
Your
NuVinci
N360
components are sealed and
well protected from the exter
nal
environment. However
, do not
use water under pressure (such
as pressure washers or water
jets) for cleaning to prevent
malfunctions due to water
penetration.
f
During the winter season, you
should clean your bicycle in
shor
ter inter
vals so that winter
road salt cannot cause any
damage.
f
Do not use aggressive cleaners.
5. SERVICE INSTRUCTIONS
Remove the Phillips screw
(1)
on the bottom of the
NuVinci
shifter and remove the bottom
cover by pulling lightly on the
access tab
(2)
.
Using a small flat screwdriver
or pointed object, extract the
cable anchors
(3)
and shift cables
(4)
from the grip pulley
.
f
Rotate the grip to access
individual cable anchors.
Install one shift cable, allowing
the shifter housing
(5)
to guide the
cable around the inter
nals until it
comes out the other side. Guide
the cable through the closest barrel
adjuster
(6)
.
Pull the cable through the
barrel adjuster until the cable
anchor seats fully into the grip
pulley
(7)
.
f
Rotate the grip to position the
next cable for installation and
repeat
5.3
and
5.4
.
Reinstall the bottom cover and
screw
(1)
. T
orque to
0.2-
0.3 N
m
(2-3 in-lbs).
4.
1
4.
2
5.
1
5.
2
5.
3
5.
4
2
1
4.
1
4.
2
1
2
3
4
5
6
7
5.
1
5.
2
5.
3
5.
4
