EN
EN
Install the shift cable hardware
following steps
A
,
B
and
C
.
3. REAR WHEEL INST
ALLA
TION/REMOV
AL
Fitting the Rear Wheel
f
Place the rear wheel into the
rear frame, making sure not to
obstruct shift cables.
Slide one no-tur
n washer
(1)
each onto each axle end. The
serrations of the no-tur
n washer
must bear against the dropout of
the frame. The rectangular boss
must engage in the dropout of the
frame.
f
Mount the axle nuts
(2)
.
Tightening torque 30 – 40 Nm
(266-350 in-lbs).
f
For rim and roller brake appli-
cations, connect the rear brake
according to the manufacturer’
s
instructions.
Improper installation of the
no-tur
n washer will result in
damage to the dropout and
the hub.
Over
-tightening may damage
par
ts. Under
-tightening can
result in the axle sliding in the
dropouts.
3. REAR WHEEL INST
ALLA
TION/REMOV
AL
Disconnecting the Rear
Wheel
f
Shift to a position that allows
easy access to the shift cable
hardware.
Remove shift cable hardware
following steps
A
,
B
and
C
.
Loosen and/or remove the
axle nuts
(3)
and the no-tur
n
washers
(4)
.
f
For rim or roller brake applica-
tions, disconnect the rear brake
according to the manufacturer’
s
instructions.
f
Remove the rear wheel.
11
12
3.
1
3.
2
3.
3
3.
4
1
2
Boss
1
A
B
C
3
3.
1
3.
2
A
B
C
3.
3
3
4
3
4
3.
4
