EN
Installation and repairs must be
made by a qualified bicycle
mechanic.
This manual assumes a level of
knowledge and skill consistent
with that of an experienced
bicycle assembler or bicycle
mechanic.
2. ASSEMBL
Y OF COMPONENTS
Installing the Sprocket
Remove the anti-shift
retainer
(1)
by pulling fir
mly away
from the
NuVinci
CVP
.
Install a standard 9-spline,
3/32 inch (2.3mm) sprocket
(2)
,
followed by the supplied sprocket
spacer
(3
, if required
)
, and secure
with the sprocket snap ring
(4)
.
f
The sprocket spacer is intended
for sprockets that are 3/32
inch (2.3mm) thick at the inner
diameter
. If the inner diameter
is
0.17-
0.18
inch (4.3-4.5mm)
thick, the spacer should not be
used.
f
The N360 is compatible with
16 to 22 tooth sprockets.
f
Install the sprocket for a
chainline closest to the CVP
.
If hub inter
face is not installed
immediately following the
sprocket, replace the anti-shift
retainer
(1)
.
The
NuVinci
N360 is incompat-
ible with 1/8 inch (3.18mm)
single-speed chains and sprock-
ets. Use 3/32 inch (2.3mm)
chains and sprockets only
.
Use of incompatible chains can
result in inter
ference with the
hub inter
face and damage to
N360 components and may
result in a dangerous condition
for the rider
.
If the sprocket is asymmetric,
incorrect installation can result
in inter
ference with the hub
inter
face and damage to N360
components and may result in
a dangerous condition for the
rider
.
See Section 6 “TECHNICAL
DA
TA” for Sprocket Ratio
requirements.
2. ASSEMBL
Y OF COMPONENTS
3
4
EN
2.
1
2.
2
2.
3
1
2
3
4
2.
2
2.
3
1
135mm
2.
1
1
Wheel Building
The anti-shift retainer
(1)
provides 135mm spacing, and
should remain on the CVP during
lacing and wheelbuilding.
f
Maximum spoke diameter is
#13 / 2.34mm.
f
Minimum spoke diameter is
#14 / 2.00mm.
Suggested lacing is a 2-cross
patter
n for 26-inch and 700c
wheels.
f
Use a 2-cross patter
n only if
the rim allows the nipples to
be effectively in-line with the
spokes.
For 24-inch or smaller wheels a
1-cross patter
n is suggested.
Radial lacing is not recommended.
