Nuvico HR-1600, Instruction Manual, Page: 59 / 86

60 HR Series NVR
8. SYSTEM
8.1. GENERAL
1.
Control ID: Each NVR that is preconfigured with the control ID is enabled to respond
to, and be operated by, the remote control.
- To select the NVR to be controlled with the remote controller, press and hold the NVR
ID button. While holding the NVR ID button, press the appropriate NVR ID number.
For example, enter 05 for NVR ID 05, enter 43 for NVR ID 43 etc. Set the ID of IR
controller on “00” to control multiple NVR’s at the same time, whatever the NVR ID is.
2.
Device Name: Type a NVR name to distinguish its location when you have several
NVR’s on a Network.
3.
KEY TONE: By default, the NVR emits a beep every time a button is pressed. Set the
key tone to OFF to turn the button beep off. By default it’s “ON”
4.
AUTO LOGOUT: You can configure the NVR to automatically log users out.
By default it’s “OFF”. [OFF 1 Minute 3 Minute 5 Minute 10 Minute]
5.
S.M.A.R.T. CHECK: Turn ON or OFF to display HDD information in the SMART
STATUS tab of the DISK menu.