10
INSTALLATION IN NEW CONSTRUCTION (
CONT
'
D
)
CI399 ELECTRAVALVE™
ELECTRIFIED INLET INSTALLATION
(CI399RK ROUGH-IN)
B
Fasten the mounting plate onto a stud. Locate the lower hole
on the mounting plate marked “Wire Trap” and use a zip tie
to secure the wire to the back of the mounting plate at the
10” mark.
C
Position the assembled wire plug through the top hole in the
mounting plate. Secure the plug to the mounting plate tab as
shown. This will keep it secure and out of harm’s way during
drywalling and finishing.
D
Run the wire to the adjacent electrical box. If the
wire is to run through a stud, drill a hole directly
on the center of the stud and run the wire through.
Strip 6 inches of outer sheathing from this end of the wire and
place the wire into the electrical box through a strain relief.
Ensure the strain relief is tightened against the outer sheathing
(do not over tighten). Leave 1/2” of sheathing inside the outlet
box. Fold the 6” of black and white wires into the outlet box.
Leave the wires to be connected by the electrician when the
outlet receptacle is being installed.
E
Once drywall and finishing have been completed, pull the
plug off the tab and snap into the opening on the back of the
new ElectraValve
®
. Ensure the plug is securely locked into
the position as shown. Attach the low voltage wires to the
screw contacts.
F
Insert the valve into the mounting plate and secure the valve
to the mounting plate with the screws provided.
CAUTION
Power tools such as routers are not recommended
for use with the inlet installation, as removal of
drywall with these devices may cause damage to
the mounting plate and/or inlet plug.
WARNING
!
All location and installation direct connect
electrified wall valves must conform with all local
and municipal building codes.
Tab
Wire
Trap
1/2” Outer
Sheathing
Low Voltage Wires
Valve
locking
tabs
AE0050A
B
C
D
E
F
