2
!
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSON(S)
OBSERVE THE FOLLOWING:
1.
This unit is intented for residential installation only.
2.
Use this unit only in the manner intended by the manufacturer. If you have questions,
contact the manufacturer at the address or telephone number listed in the warranty.
3.
Before replacing filters, servicing or cleaning unit, disconnect power cord from
electrical outlet.
4.
Installation must be done in accordance with all applicable codes and standards,
including fire-rated construction codes and standards.
5.
This unit is not designed to provide combustion and/or dilution air for fuel-burning
appliances.
6.
When cutting or drilling into wall or ceiling, do not damage electrical wiring and other
hidden utilities.
7.
Do not use this unit with any solid-state speed control device other than optional wall
controls C
3
4, CMR or ACCGSC
3
.
8.
This unit must be grounded. The power supply cord has a
3
-prong grounding plug for
your personal safety. It must be plugged into a mating
3
-prong grounding receptacle,
grounded in accordance with the national electrical code and local codes and
ordinances. Do not remove the ground prong. Do not use an extension cord.
9.
Do not install in a cooking area or connect directly to any appliances.
10.
Do not use to exhaust hazardous or explosive materials and vapors.
11.
Do not run any air ducts directly above or closer than 2 ft (0.61 m) to any furnace or
its supply plenum, boiler, or other heat producing appliance. Do not connect the unit
ducts to the furnace ducts, neither return plenum or supply.
12.
When performing installation, servicing or cleaning the unit, it is recommended to
wear safety glasses and gloves.
13.
When the federal, provincial or state legislation comprises more restrictive installation
and/or certification requirements, the aforementioned requirements prevail on those
of this document and the installer agrees to conform to these at his own expenses.
CAUTION
1.
To avoid premature clogged filters, turn OFF the unit during construction or renovation.
2.
Please read specification label on product for further information and requirements.
3.
Be sure to duct air outside – Do not intake / exhaust air into spaces within walls or
ceiling or into attics, crawl spaces, or garage.
4.
Intended for residential installation only in accordance with the requirements of NFPA 90B.
5.
The ductwork is intended to be installed in compliance with all local and national
codes that are applicable.
6.
Do not use the AE60, EA 1500 or HV 1.5 unit when varnishing. Furthermore, if the
unit is installed in the attic, it is highly recommended to block the stale air intake and
fresh air register. The varnish vapors may damage the unit.
7.
At least once in a year, the unit mechanical and electronic parts should be inspected
by qualified service personnel.
8.
If the AE60, EA1500 or the HV 1.5 unit is installed in the attic, the unit should not be
turned off during the winter time in order to avoid condensation inside the unit and
inside the ducts.
9.
During snow/rain storm, operate the unit in recirculation mode to prevent water build
up in the ventilator.
WARNING
