Nussbaum SPL 3200, Operating Instruction And Documentation

Page: 25 / 43

• Lower automotive lift to lowest position and lift it afterwards 500 - 600 mm. Both
ropes must be tightened lightly. In any other case the self-locking nuts at the upper
side ob both carriages must be adjusted again.
Pay attention that each of the two ropes is tightened regulary and that it is
not too slack, otherwise exactly synchronization can not be guaranteed.
Pay attention that the ropes are not too tight, otherwise there is the
possibility that the lift jerks, or that the lift is too slow while lowering
The ropes don’t carry load. They must regulate an exactly synchronization
of the lift.
• Install carrying arms (refer to data sheet Power-Lift), lubricate bolts and secure
them with enclosured circlips at both ends.
The bolts of the carrying arms must be secured at both ends, otherwise a
safe connection between carriage and carrying arm can not be
guaranteed.
• Deaerating the lift: lower the lift to lowest position. loosen thread joint at lower side
of cylinder which must be deaerated. Lift the lift until oil comes out of the thread
joint. Now close the thread joint and fasten it.
In case the lift jerks while lowering there are two posibilities: the
synchronizing ropes are too tight or oil is in oil circulation (deaerate
according to instruction ahead)
• Loosen ratchet (now it the tooth of the ratchet can engage in ratchet strip again)
• Hang up long ratchet-rope with end nipple in ratchet at column of opposite side.
Take free end of the rope through rope-guidance tube to topside and afterwards take
it through the rope-guidance tubes at traverse and at column of operating side to
lower side again (see pic. 5).
• Mount thimble at end of the rope.
• Hang up ratchet-ropes with accompanying spring in operating lever ”lowering”;
operating lever is in initial position.
• The short ratchet-rope with end-nipple is already preassembled.
• Installing of the ratchet-ropes: Both ratchets mustn’t be engaged when operating
lever is completly pulled. The difference between backside of the ratchet and
column should be approximatly 60 mm (refer to pic. 6).
• For adjusting it might be necessary to loose one ratchet-rope and to strech the other
one to guarantee same position of both ratchets.
The ratchets must be free and their function must be guaranteed in any
case.
2 5
Instruction and Documentation
SPL 3200