Emergency lowering
• In case the ratchets are engaged turn operating switch to position "
↑
", lift it a little
bit until the ratchets are unlocked.
• Let go of operating switch and lock it in position "
0
"
• Take off coverings from ratchets and look which of the ratchet-ropes is torn.
• Pull back the relevant ratchet and lay a suitable support between ratchet-strip and
ratchet or fix the pulled back ratchet with the help of a wire to avoid reengaging of
the ratchet-tooth in the ratchet-strip. This measure is to do at this ratchet where the
ratchet-rope is torn.
• Lower vehicle to lowest position (as described in chapter ”operating instructions”).
Refer to the regulations ”Lowering”
• Take off support or wire from ratchets that the can engage again.
To guarantee the safe running of the lift the supports must be removed
from the ratchet to bring the ratchet in its normal function
• After finishing with emergency lowering reinstall coverings.
• When the lift is in lowest position, slew carrying arms inside and drive vehicle out
of the lift
After finishing with emergency lowering the lift must shut down until the
defective ratchet has been replaced.
Torn rope
In case the safety-rope is torn the height limit switch and the switch off strip under the
traverse is witchout function. The lift must shut down until the defective rope has been
replaced. The new safety-rope must be installed as described in the following instruction.
• Disconnect power supply (disconnect feed line)
• Hang up safety-rope at topside (see pic. 5) and pull it through the empty rope
guidance tube
• Hang up safety-rope in boring of the flat rolled steel (backside at operating switch).
Turn operating switch to position "
↑
" and adjust length of the rope that the rope is
streched not too much.
Streching of the safety-rope: a small activation of the switch-rod or of the
switch-off strip must pull the operating switch to position ”0”.
• Connect power supply
In case the safety-rope in not torn, only slack, the rope must only be adjusted again after
disconnecting the lift from power supply
2 1
Instruction and Documentation
SPL 3200
Summary of Contents for SPL 3200
