NUOVA ELETTRONICA DSP LASER, Instruction Manual

Page: 16 / 66

DSP LASER
12 DSPLSR01EN
At last, the management of the procedures of stop, suspension and reactivation of the
machine are entrusted to the main control board of the machine itself.
DSP LASER is available in more versions which differ for the following main characteristics:
•
Blanking type: “Stop&Go” or with “Enabling by operator”
•
Central receiver: optional or in different positions, allowing the use with machines
whose stop space is included within ranges of different values
•
Function of check, at switch-on, of the presence/absence of the stop space
•
24Vdc power supply for TX and RX modules
•
24Vdc power module and OSSD relay outputs (ALdc)
•
Power supply module with filter and power supply transformer by 220Vac or 24Vac
(AL1B)
•
Power supply module with filter and power supply transformer by 220Vac or 24Vac
and OSSD outputs with relay (AL2B)
The codes identifying RX module of DSP LASER with the corresponding configuration are:
The codes identifying TX module of DSP LASER with the corresponding configuration are:
RX x x x x
A
: Blanking mode “
Enabling by Operator
”
B : Blanking mode
“
Stop & Go
”
See Chp. 10.1.3 Pag. 17
0 : Opt. Rec. Ele absent S.A.: between 0 and 7mm
2 : Opt. Rec. Ele present S.A.: between 3 and 14mm
See Chp. 10.1.4 Pag. 25
0 : Function STOP SPACE CHECK ABSENT
1 : Function STOP SPACE CHECK PRESENT
See Chp. 10.1.4 Pag. 25
RX : Receiver module
0 : Function RESTART INTERLOCK ABSENT
1 : Function RESTART INTERLOCK PRESENT
See Chp. 10.1.5 Pag. 29
TX x
TX : Transmitter Module
0 : TX suitable to RX with option 0 of S.A.
(0: when RXA0xx or RXB0xx is used)
1
: TX suitable to RX with option 2 of S.A.
(1: when RXA2xx o RXB2xx is used)
dc : 24Vdc power supply