NUOVA ELETTRONICA DSP LASER, Instruction Manual

Page: 65 / 66

DSP LASER
DSPLSR01EN 61
19. Technical characteristics
ELECTRICAL DATA
•
Power supply:
Voltage: Direct 24Vdc or with ALdc module; 24Vac or 230 Vac ±10% freq. 50 Hz / 60 Hz
with the use of AL1B and AL2B modules:
Consumption with: Standard 10V/A - ALdc 14 V/A - AL1B 10 V/A - AL2B 14 V/A
•
Two solid state OSSD outputs 24Vdc 100mA. Standard or with AL1B
•
Two OSSD outputs realized with force-guided relays with 1 NA contact each one.
Maximum load switchable for each pair of contacts: 2 A for 24 Vac/dc. The outputs
must be protected with fuses of the type indicated in the connection diagram. For
inductive loads, it is necessary to install an arc switch-off device in parallel to the load.
•
Clamps extractable on TX, RX and AL for cables up to 0,75 mm
2
. Cable section area
suggested: TX 4x0,75 - RX 16x0,22.
OPTICAL DATA
•
Laser light source visible 650 nm
•
Beam divergence: < 0,2 mrad
•
Laser classification: class 1 M
•
Dimensions of laser beam at TX output:
Complex geometrical figure contained in a rectangle area 48mm X 24 mm
•
Maximum operating distance in standard atmosphere and absolute absence of fine dust:
15 m
•
Operating distance suggested: 0,5 ÷ 8 metres in normal industrial environment
GENERAL DATA
•
Feedback time: 5 ms with AL1B; 15ms with AL2B and ALdc
•
Detection capacity of the central and front area: >14mm
•
Protection level of the cases: Transmitter and Receiver: IP 65 - AL: IP 20
•
Operating temperature: from 0°C a 50°C
•
Material of the containers:
TX and RX: painted aluminium, PVC reinforced with glass fibres, polycarbonate
AL: NORLY UL94 V-0
•
Dimensions:
TX and RX (fairlead and cable excluded): 192 mm x 128 mm x 81 mm
AL1B and AL2B: 88mm x 87mm x 53mm
•
Mass
TX (with fairlead but cable ext.): about 1250 g
RX (with fairlead but cable ext.): about 1150 g
AL1B: about 420 g
AL2B: about 455 g
•
Maximum standard length of the connection cable of TX and RX to the electrical board:
20m