DSP
LASER
DSPLSR01EN
19
The safety device DSP LASER can realize the blanking function in two different ways,
depending on the installed firmware version. It is necessary to be sure which of the two
operating modes is present in the device.
The two different blanking functions foresee the same operating characteristics of the
blanking state. The difference is the way the blanking state is reached and maintained. The
selection of more operating modes at the same time brings to a condition of lock of the
equipment until when the failure has been removed. The absence of selection of any
operating mode causes the equipment operates in mode 1, then with all the sensors active.
In mode 2 the activation of the OSSD outputs, which allow the HIGH SPEED downstroke of
the machine, is always preceded by a consensual operation of the operator for both the
blanking modes. The active state of the blanking function however depends on a time,
elapsed which DSP LASER returns to the state which obligates the start of a bending cycle
with the blanking function deactivated.
Summary of Contents for DSP LASER
