NUK VAPO RAPID, Operating Instructions Manual

Page: 23 / 102

19
7. Faults and their rectification
8. Technical data
European Model, with 2-PIN plug
(Article No. 10.251.012):
Voltage: 220 - 240 V~/50 Hz
Power consumption: 550 Watt
British Model, with 3-PIN plug
(Article N. 10.749.054):
Voltage: 220 - 240 V~/50 Hz
Power consumption: 550 Watt
Fault Cause Rectification measures
Disinfection takes too long Too much water in receptacle Measure exactly 70 ml for optimum
disinfection
Base is heavily scaled Descale base (see “6.2 Descaling” on
page 18)
The device does not switch on,
Control light
8
does not light up
No power supply Push plug in correctly
Check with other equipment as to whether
the socket has power supply
The device does not switch on
again after use, control light
8 is
lit up
Overheat protection is active Wait 15 minutes for the device to cool down.
6 FIRST CHOICE bottles do not
fit into the device Components not placed in
correctly Place bottles upside down in the bottle
holder and without accessories.
Stack lids in bottle holder and then place the
basket on top
Bottles are very hot after disin-
fecting Bottles are disinfected at
above 90 °C Allow bottles to cool down
Use the tongs supplied
Bottles and accessories show
white marks after disinfecting Device has limescale deposits Descale device (see “6.2 Descaling” on
page 18)
Steam is flowing out of the
accessory holder Device has not been assem-
bled correctly Assemble device correctly (see
“5.2 Disinfection” on page 17)
Bottles and accessories are
not suitably positioned in
holder Separate the components so that the device
seals completely (see “5.2 Disinfection” on
page 17)
Vaporisator 09/08 Seite 19 Dienstag, 7. Oktober 2008 8:17 08