635 W. Michigan Street Orlando, FL 32805 · PH 407-426-7674 · Fax 407-426-7721
http://shop.bluworldusa.com · www.nu-flame.com
SETUP INSTRUCTIONS FOR FIAMME
Read and Understand the entire Nu-Flame Manual prior to use.
Make certain to inspect the package thoroughly. Carefully remove and unwrap your Nu-Flame fireplace.
Your fireplace will have the following components:
1.
Black High Heat Powder Coated Base
2.
Wind Screen Glass Panels (2 each)
3.
Stainless Steel Burner
4.
Dampener tool
You may wish to purchase a funnel for pouring fuel into the burner
Place the base on a flat, stable surface. Drop the burner in the cutout of the base.
Slide the wind screen panels inside the
cutouts of the base. Make certain they are
well seated inside the base and sitting level.
Use only a recommended Ventless Fireplace
Fuel like “Nu-Flame Bio-Ethanol Fuel”. Make
certain the sliding dampener on the burner
slides easily back and forth and is completely
open prior to filling. Make certain the burner
is clean and free of dirt or packing debris.
Pour fuel into the burner using a funnel. The
burner should be no more than 2/3 full. DO
NOT OVERFILL. Wipe up any spilled fuel. Use
a long match or extended lighter to ignite the
fuel.
Use the included dampener tool to open and close the dampener, adjusting the height of the flame or to
extinguish the fire completely.
CAUTION: The flame starts out slowly. Please allow 15 minutes to reach the optimum temperature and
flame height. DO NOT ASSUME THE FUEL DID NOT IGNITE. Follow the refilling instructions in this manual.