nStor 4100FS, User Manual

Page: 53 / 168

Chapter 3 - Setup and Installation
Completing the Installation
41
a Ensure that the orientation is such that when the power cord is inserted,
the bale will be the top of the cord and will fit over and onto the cord.
Attaching the Power Cord Bales
b Connect the other end of the power cords into a three-hole grounded
outlets or UPS power system.
c Repeat steps 2(a) and 2(b) for the other power cord.
3 Repeat the above steps for each additional storage system enclosure you will
be installing.
This completes the physical hardware installation.
Before You Continue...
The next section, Enclosure Configuration, includes steps and diagrams for
setting the SAF-TE Disk I/O card switches and attaching the required SCSI data
cables for each drive configuration. Locate the applicable configuration and refer
to the steps and diagrams to set the card switches and cable your system.
The Topology Host Cabling section includes steps and diagrams for cabling the
primary RAID storage enclosure to the host computer(s). Review the procedure
steps, then locate the applicable topology and cable your system based on the
diagrams.
The last section of this chapter provides the steps to properly power on or power
off your storage system.
Bale fits over and onto
the power cord.
4100FS.book Page 41 Tuesday, July 8, 2003 4:35 PM