NSI MIDI 616, Operation Manual, Page: 30 / 42

25
Configuration Mode Switches
CHANNEL
NUMBER FUNCTION
Channel 1 USE - This slide control is used If your sequencer generates automatic “note-off”
commands, and lights go off by themselves mysteriously during playback.
LED OFF - “Note-off” commands and “note-on = 0” commands are accepted.
“Note-on = 0” is sent for light off.
LED ON - Except for FLASH, “note-off” and “note-on = 0” commands are
ignored. “Note-on = 1” is sent for light off.
Channel 2
USE - This slide control is used if your sequencer auto-corrects “note-on” values
without moving corresponding Control Changes.
LED OFF - Control Change #1 is sent as FADE RATE.
LED ON - “Note-on” CO is sent as FADE RATE.
Channel 3
USE - To change starting note number for scene changes.
LED OFF - C3 is lighting Channel 1.
LED ON - C2 is lighting Channel 1.
Channel 4
USE - To change starting note number for flashes.
LED OFF - C6 is flash Channel 1.
LED ON - C5 is flash Channel 1.
Channel 5
USE - If sequencer does not leave FADE RATE at beginning of “note-on”
sequence.
LED OFF - FADE RATE is transmitted immediately before lighting levels.
LED ON - Slight delay is inserted after FADE RATE.
Channel 6
USE - Sequencer automatically transmits Control Change #123.
LED OFF - Control Change #123 is used as RESET command.
LED ON - Control Change #64 is used as RESET command.
Channels 7-16 RESERVED