Copyright Harmsco
®
Inc.
All rights reserved.
1243-HP, MANUAL - HUR FL
Page 24 of 25
HARMSCO
®
Hurricane
®
Swing Bolt Water Filters
Cartridge Replacement Instructions (Quick Reference):
For Filter Housings With Swing Bolt Closure.
* * NOTICE * *
THE FOLLOWING INSTRUCTIONS MUST BE READ AND FOLLOWED PRIOR TO USE.
1.
Always Isolate And Remove Pressure From Housing Before Servicing.
Housing is to be shut off and drained of fluid by first opening the lower drain.
2. Open filter housing by turning Eye Nuts counter-clockwise, disengaging
Swing Bolts, and removing Lid. Take out used cartridge(s) and remove
cartridge
lifting
handle(s).
3. Remove new cartridge(s) from packaging and make sure center cores are
clear of all obstructions, dessicants and shipping materials.
4.
Install cartridge lifting handle(s) into cartridge(s).
5.
Insert Cartridge(s) into housing and onto Stand-pipe(s), cartridge(s) is(are) to
contact Tube Sheet of housing.
6.
Position housing O-ring seal in groove of housing.
7.
Position Lid onto housing and properly align on O-ring before applying Swing
Bolts. Do not allow tilting or cocking of Lid on the O-ring.
8. Close filter housing by tightening Eye Nuts clockwise by hand. Use a “star/
criss-cross” pattern several times to tighten all of the Eye Nuts uniformly tight.
9. Open inlet valve and allow fluid to fill housing.
10. Open outlet valve.
11. Flush unit (through outlet) to drain for 10 minutes at recommended flow rates
prior to use.
Should a leak appear at the housing O-ring, isolate and relieve pressure
and repeat steps 6 through 11. Always isolate and remove pressure from
housing before servicing any part of filter.
This product is manufactured under one or more of the following patents: U.S. NO.
4,187,179; 3,720,322; CANADA NO. 977,693; GT. BRIT. NO. 1,372,014; W. GERMANY
NO. 2,261,817; FRANCE NO. 7,246,864; EUROPEAN NO. 0,191,844, Other patents pend-
ing.
Harmsco
®
Filtration Products
With Patented Up-Flow Filtration Technology
www.harmsco.com
(561) 848-9628