Now Technologies Gyroset Link, Manual

Page: 16 / 24

Using the head drive function
PREPARATIONS
1. Find a comfortable seating position for the user and adjust the headrest so that
is always in the reach with the headset’s mode button. It is recommended that
there is a distance of 3-5 cm between the headset’s button and the headrest.
2. Turn on the headset, and place it on the user’s head, adjust the click sensor’s
flexible tube as described in Headset User’s Manual. The sensor should be placed
approximately 1 cm from the movable part of the user’s face (corner of the eye,
cheek, corner of the mouth etc.)
3. Turn on the Omni.
4. Select drive mode on the headset by a long press on the mode button.
DRIVING
1. Imagine that Your head will act like a regular joystick.
2. Press the headset’s mode button shortly against the headrest then return Your
head into a neutral position and keep it there until the countdown stops. This is
necessary to measure Your personal neutral position and enables You to change
the position from time to time.
3. The countdown will start, GyroSet Link will mark every second with a beep. Control
starts when the countdown is at zero, marked with higher and longer beep tone.
4. Tilt your head to the direction You wish to go. The amount of tilt is proportional to
the speed of the wheelchairs movement.
5. To come to a halt, move your head into the neutral position (into the dead-zone)
6. To stop driving press the headset’s mode button against the headrest.
For each control session any new neutral position can be selected.
16